Fitting Wiring Loom

[donsrno1]

How difficult is it to fit a new wiring loom to an engine with the engine still in place?

I'm just wondering as I went to see a valver today but I think some wires to the sensors have been cut off as there were no connectors to the CTS and whatever is next to it and I couldn't see them anywhere else.

Can you get a wiring diagram anywhere?

Thanks.

 

[donsrno1]

^^^^

 

[InsaneManiac]

There may be one in the haynes manual for your car, but don't hold out much hope. They are not as detailed as they used to be.
Matt

 

[mr.k 16v]

its not that difficult but u still have ur engine in place,so ithink it will take longer than usual,remember u got to feed wires and sensors all over the place,could do with takin the engine out?

 

[donsrno1]

Unfortunately I wouldn't be able to take the engine out. I'll have another look at the car and have a better look to see if I can find the connectors.

Is there any possible reason why they would have cut off the CTS connector and the connector for the dark borwn plug next to it from the loom?

 

[donsrno1]

Just checked the haynes. It's not the clearest for a bit of a wiring novice like myself, are there any diagrams anywhere which show basically what branches off where as I reckon that would make it a lot easier to work out.

 

[mr.k 16v]

haynes manual is pants for electrical probs,anyway u can sort the missing parts from another motor