glovebox lid

[ck_dark_]

seen people post about removing the glovebox, but no replies.

is it possible to remove the the glovebox lid? cos i wana spray it

 

[DaveLiquid182]

It is rivetted but i suppose it would not be difficult to drill them out then re-rivet it.

 

[Gibson&BoyneTrimming]

seen people post about removing the glovebox, but no replies.

is it possible to remove the the glovebox lid? cos i wana spray it

Hiya

It is possible to remove it..

Open the glove box, at the bottom of the lid in each corner there are 2 little pins..You have to get a small screw driver and push them in towards the centre of the glovebox..
It will then fall out..
Then all you have to do is remove the strap and this should pull out..

Simple..

If you get stuck..give us a bell tomorrow on 02380 260045 and we'll be happy to help.

Ffion
Gibson&Boyne Trimming
*Come see us at FCS

 

[ck_dark_]

ah cheers will give it a try, even a helpline provided!

 

[Gibson&BoyneTrimming]

We do our best..

Ffion
Gibson&Boyne Trimming
*Come see us at FCS

 

[Gibson&BoyneTrimming]

ah cheers will give it a try, even a helpline provided!

We do our best..

Ffion
Gibson&Boyne Trimming
*Come see us at FCS

 

[Josh@Renparts]

anyone know what causes them to sag at one side? and the strap, does that just click out if you pull it hard enough?
thanks
josh

 

[Gibson&BoyneTrimming]

anyone know what causes them to sag at one side? and the strap, does that just click out if you pull it hard enough?
thanks
josh

If its sagging at one side..either the pin is broken and you could replace it with something like a drill bit or you can push the pin back across if its still there..

Be gentle with the strap - you could minipulate it out but really you could do with a trim lifter underneath it..then it will pop out no problem.

Ffion
Gibson&Boyne Trimming
*Come see us at FCS