Grp N or Grp A Exhaust

[bondy]

looking at omp system iv got a valver with cams stage two chip pbv zorst but no head work and its making just over 150 at the fly wat do you all rekon all advice welcomed. bondy

 

[u33db]

Dunno about the group A/N zorst m8! Ive got the same setup as you with full BB decat and think the next best option will be a stainless manifold (seen reports of up 8bhp with these) - i cannot see the group A/N zorst beating a decent stainless system with a manifold.... If i was you id rather spend the money on a decent manifold and gasflow rather then discarding the system youve already got....

 

[BenR]

i got one off the williams, its loud and farty............

its cheap, and does the job i require.

 

[Adams_16v]

bondy u still got the k-tec on at the minute mate???

 

[Nick Read]

LOL if he did Id be able to hear him start the b*****d up every morning over in Kent - and Im here in Essex!

 

[bondy]

yup iv still got it thanks nick hows your car ? . by the way ben dont you have to change the angle of the cat i had to when i put a williams magnex system on my car, i found it lost loads of torque?

 

[BenR]

im not using a willy cat.

 

[bondy]

so i take it you havent got a standard 16v manifold on yours then ?

 

[BenR]

no, its std.

 

[bondy]

sorry mate i actually meant downpipe is that standard ?

 

[Mike Wright]

Christ Bondy this is a rare visit mate!

 

[BenR]

Quote: Originally posted by bondy on 10 September 2003

sorry mate i actually meant downpipe is that standard ?

yup

 

[bondy]

u get them prices ok mate ???

 

[BenR]

ta!