HID problem

[Taylor..]

I've got a mk2 ph1 that has h4 bulbs, but I've bought some dual optics and I want to put in 6000k hid kit, I know you have to re wire them in but me and a mate tried and it burnt the back of my instrument panel. Just seeing if someone could tell me how to wire the hid kid properly. Also all the kits I looked at dont come with the wire which has a fuse and resistor on.

thanks in advance

 

[McGherkin]

You've probably wired the Dual Optics incorrectly.

The HID kit should simply be connected in the same way as a conventional bulb.

 

[Taylor..]

So I won't need a live to the battery as that's what it's Like for the h4 hid's ?

 

[McGherkin]

What on...

The positive wire is run from the existing H4 connector, as is the positive for the high beam, and they share a neutral wire.

Can you show a pic of how you have it wired at the moment? Both sides.

 

[Taylor..]

Basically, when I had the standard lights in I had a hid kit for the h4 bulbs, and that kit can with a wire that attached to both lights and then to the battery with two earths at either ends for each light, but with a hb3 hid kit, it didn't come with that wire.. That wire also had a fuse on it and a resistor..

 

[Taylor..]

Right Ive got some pictures to explain better

This is the HB3 HID kit i've got:

This was the one for my H4 bulbs :

What I was trying to say is, is the HB3 kit right not to have the big long wire with the fuse on ? Or do I need that wire ?

I also got these from the scrappy if they are any help ?

Any help is hugely appreciated

 

[McGherkin]

The HB3 kit is right. The positive and neutral wires go into the red connector on the ballast, then the bulbs plug into the other connectors from the ballast.

 

[Poopensharten]

You have to reverse the polarity IIRC

 

[Taylor..]

So to wire them up do I use that hb3 connectors I got and wire them to the h4 connectors ?

 

[McGherkin]

Yes, along with the high beam bulbs.