how to build your own ktr induction kit

[cliosport-carl]

Can someone help with this just the size of the bend and the length of it or even a link to eBay for it thanks

 

[Rubicon_]

Here you go mate.

 

[Malaman172]

Sorry for being simple but how do you put it all together? What's the edge trim for?

 

[hipwell]

I recon. There's a bit missing there.

There should be another 90 degree bend to aim the filter into the area behind the bumper.

The trim is probably a different purchase

 

[Jack 172]

Yup need 2, still near 100 quid, get a second hand ktr one for 120? Then you got a solid silicone tube too

 

[dlee182]

Or you can buy x2 150mm (legs) 90deg aluminium bends, maybe a 100mm straight incase extra length is required somewhere, x1 100mm straight hose (cut in half) and a filter all 70mm plumbing. Get someone to weld the pipes for you at the required angle. This will be enough to get the filter in the bumper. This will be a lot cheaper than using silicone pipes and less prone to any collapsing. I would have done this myself yesterday but as there was already some form of induction setup there I utilised that somewhat to get the same outcome.

 

[Danith]

I bought a hill power 90 deg elbow (with breather) 90 deg aluminium elbow off ebay and a shitty ebay cone. worked a treat. need a smaller battery though.

 

[brohoward71]

Why not just use these.
An Idea I shamelessly stole from MRTOM project thread :rasp: and will be using on mine
Yes the 90 degree bend says 50mm on there but you just choose 70mm before checkout