How would you undo these?

[Waitaboutery]

Fucked top mounts. The nut will not shift and both allen key holes are cracked/rouned?

 

[iimushroomzii]

Angle grinder.....

 

[Coby.]

Impact Wrench???

 

[Waitaboutery]

Impact wrench just spins the strut shaft and spring top mount.

 

[Fred@BTM]

impact/air gun will do them no bother

 

[Waitaboutery]

Tried it fred. Its just spins the spring top mount round and round and round.

I don't really want to be pulling an apex spring out of my leg lol

 

[Cro]

Get a vice or clamp on the strut to stop it turning, or cut a slit into the strut tops and put something in to stop then turning while using the spanner

 

[Waitaboutery]

Will do. Going to have another crack at it when i'm not so stressed

 

[Fred@BTM]

you got a mickey mouse air gun or something!

 

[A18XHO]

air gun will get it straight off. Sure your not using a drill?

 

[Waitaboutery]

you got a mickey mouse air gun or something!

Got a little one.

A 300nm one and a 1800lb/ft one. I didn't want to use the big ones. I'll have a crack with the 300nm one.

 

[kev 3dr]

drill some small holes down one side of the nut the sharp chisel to finish splitting the nut ;-)


PS how will a air gun get it off if the hole lot is spinning and you cant grip the shaft anywhere ????

 

[halla26]

pour buckets loads of ease-it on, its a releasing oil, normally helps us in work if something won't budge

 

[Fred@BTM]

heat the f*****s up too, melt the nylock

 

[Waitaboutery]

I love my gas axe

 

[mini-valver]

Grind some cuts into it them smash em off with a hammer. You'll need new damppers though, lol.

 

[ben_r1]

F type on the strut will keep it from spinning?

 

[powey]

Mole grips and a cloth on the strut to hold it

 

[Alastair.]

tnt

 

[Renault Davey Boy]

If you place a hand grenade on top of the nut pull the pin and shut the bonnet, you know when to open the bonnet again as you will hear a slight tap on the bonnet this means the grenade as detonated, open bonnet and ta da the nut is off easy when you have the know how and correct tools

 

[Cupster]

Burn it, the car not the not. Problem solved?

....or may I suggest a hammer!

 

[Waitaboutery]

I got them off with a 1800lb/ft air gun.

Took about 1 millionth of a second. I was very scared though.