roof lining

[Gaz_]

anybody removed it, or is it a no no?

i've got a rattle from mine (99% sure its the arial cable rubbing against it) and its right above me head, which is annoying........

help people!!!!

 

[RacerStu]

Just pull on it I think from the top of the windscreen? Think its just stuck down. Could be wrong though

 

[hellsbells]

it is very delicate so be careful. wen i had my aerial ripped out of my car i had it remove my lining and it is so flimsy!!!! reno were going to charge me 150 for it so i did it myself!! good luck!!

 

[lemonnobby]

its bonded all over the roof.

 

[Rob.]

mine didnt go back on very good after i removed it

 

[Gaz_]

took it off today, seems the rear hadn't bonded properly, causing the rattle/vibration, refitting again tommorrow with LOADS of stickaflex lol

pretty straight forward to remove, just remembering to take your time lol

 

[kpowell911]

looking at mine it looks kinda difficult to do around the sun roof and interor light mechanism?

 

[Gaz_]

cup = no sun roof

 

[kpowell911]

ah

 

[Tigger]

Yeah - dam sunroof is only a novelty :S a rattling one too

I'm finding it difficult to get some of the clips removed - just hard to budge :dapprove:

 

[Tigger]

:bump:

 

[V1NNY]

i want to take mine off and dynamat it

 

[Tigger]

That's exactly what I have in mind too
Might even save a few quid and retrim the headcloth in alcantara to complement the install that im putting in. seen a clio with it done - looked awesome

 

[Final Maxim]

lol i had to take mine out on my mk 1, it was bonded in had to pull it down n get a blade down the back n slice it. the roof was bowing to f**k, lol, v v flimsy. bolloxed all my knuckles up doing that :\

 

[Tigger]

It seems like the material is stiff enough in mine, it's the plastic trim and other gizmos that's holding it up that are annoying me :dapprove:
pull too tight and the car would probably fall apart lol, well something would break at least without a doubt

 

[Tigger]

How do you get the clips for the sunvisors out? I've taken out all the screws and the sunvisor itself is down but the clip for securing the visor won't budge

 

[Gaz_]

its a t**t..... best way i found was undo the torx screw fully, then i think the clips need pushing together and pull down whilst 'rocking' front to back if that makes sense? the grab handles are the same and a poor idea imo

 

[Gaz_]

don't f**k up the lining they are 250 notes new!!!!!