Rota TFS3

[scott.kir]

Hello,

Has anyone had any experience of fitting Rota tfs3’s to a clio?

You can get them in 15x7 and quite a few different offsets but unsure if regardless of this some wheels just wont clear the calliper or not?

 

[Cronin_Motorsport]

Found this thread through Google as I’m about to collect some tomorrow I’m basically the same spec as Cup Turini’s but in ET35

I currently run PMS 18mm hub centric spacers up front and PMD 10mm rear axel spacers so in theory these should be same but with a tiny bit more poke.

mid that’s the case then I’ll have to fit my camber bolts and get same camber shims for the rear

Did you get around to fitting some?

 

[scott.kir]

Found this thread through Google as I’m about to collect some tomorrow I’m basically the same spec as Cup Turini’s but in ET35

I currently run PMS 18mm hub centric spacers up front and PMD 10mm rear axel spacers so in theory these should be same but with a tiny bit more poke.

mid that’s the case then I’ll have to fit my camber bolts and get same camber shims for the rear

Did you get around to fitting some?

I didn’t... i went with the play it safe what everyone else has (2118’s 😂)

however i will probably be after a set when i see yours fitted, Upload a photo when you do

 

[Darryl_1983]

They're basically a copy of the Enkei rpf1 wheel. Ultralite do a set too, if you search these, you'll find a few examples.

Post #3614

The PH1 172 Appreciation Thread.

Just seen this on FB, unsure if theyre on here.. Looks great! This is the one that was at the ring this week , looks bloody lovely [emoji4]

cliosport.net

Ultralight F1 alloys

has anybody fitted these to the clio? they look similar to the o.z f1 http://www.ebay.co.uk/itm/401173949644

cliosport.net

 

[Cronin_Motorsport]

Found this thread through Google as I’m about to collect some tomorrow I’m basically the same spec as Cup Turini’s but in ET35

I currently run PMS 18mm hub centric spacers up front and PMD 10mm rear axel spacers so in theory these should be same but with a tiny bit more poke.

mid that’s the case then I’ll have to fit my camber bolts and get same camber shims for the rear

Did you get around to fitting some in

I didn’t... i went with the play it safe what everyone else has (2118’s 😂)

however i will probably be after a set when i see yours fitted, Upload a photo when you do

I’ve had all the usual wheels you’d find so I wanted something different.

they arrived today and I’m very pleased. Will keep you updated once they’re back from my detailer for a ceramic coat and tyre fitting

 

[Cronin_Motorsport]

Got them on finally. I went with 16X7 ET 38.5, the needed spigot rings but that was it. I ceramic coated them inside and out and fitted some 205/45/16 Toyo Proxes T1R. 18mm PMS front hubcentric spacers and rear 10mm PMS axel spacers. I like the fattier look of the tyres at this sizes over the stiffer looking side walls of AD08R’s for example.

No rubbing at this height either so may drop the front a tad but very happy with them and they’re super light too!