Spacer the same as moving axle?

[bozothenutter]

apparently the rear axle could do with being moved 5mm to the right.
would adding a 5mm spacer on the right have the same effect?

 

[robzracing]

Not ideal but yes, an axle spacer will work.
Not a wheel spacer though.

There is a bit of adjustment on the rear subframe if you loosen all the bolts so you might be able to do that.




Sent from my iPhone using Tapatalk

 

[bozothenutter]

Not ideal but yes, an axle spacer will work.
Not a wheel spacer though.

There is a bit of adjustment on the rear subframe if you loosen all the bolts so you might be able to do that.




Sent from my iPhone using Tapatalk

Was indeed the stubaxle spacer I was talking about.
With all the bolts you mean the one holding the brackets in right?
The ones everybody is always moaning about?

 

[robzracing]

Was indeed the stubaxle spacer I was talking about.
With all the bolts you mean the one holding the brackets in right?
The ones everybody is always moaning about?

Yes those are the ones. 6 in total.
Just out of interest have you checked you’ve got the same stub axles on both sides?
172cup axles were about 5mm thinner than standard. I found this on my car a couple of years ago.


Sent from my iPhone using Tapatalk

 

[bloke]

spacer in behind the bearing?

 

[Crayola]

Have you replaced your axle bushes?

Also are you sure the stub axles are identical as 182 cup ones are thicker

 

[bozothenutter]

spacer in behind the bearing?

Yup....I'm religious about those

 

[bozothenutter]

Yes those are the ones. 6 in total.
Just out of interest have you checked you’ve got the same stub axles on both sides?
172cup axles were about 5mm thinner than standard. I found this on my car a couple of years ago.


Sent from my iPhone using Tapatalk

Never looked at those...🤔

 

[robzracing]

Never looked at those...[emoji848]

Sent from my iPhone using Tapatalk

 

[bloke]

5mm is a lot so would be worth checking stub axles as already mentioned. Does it drive ok? How did you find out it was 5mm out?

 

[bozothenutter]

5mm is a lot so would be worth checking stub axles as already mentioned. Does it drive ok? How did you find out it was 5mm out?

yeah I know, found out from an alignment see this topic.
offset is 0°.07min, plugged some numbers (wheelbase, centerline angle, offset angle) into a Pythagoras website and it came up as 5mm

it also has a problem with camber.

it now drives ok, slight pull under braking and seems to prefer left hand corners.

 

[bozothenutter]

like this.....