STOP/BRAKE light flicker on dash, fluid level fine, breaking solid?!

[Bento456]

Got the STOP light and brake symbol on the dash flickering alot when driving. My fluid level is perfect...
Ever since I got the tracking sorted, this problem started happening? What could they have done when adjusting the tracking to cause this??

Thanks.

 

[MartinR]

maybe catched the abs sensor wire?

 

[mad in general]

I believe that the electrical contacts for the rear light clusters will be at fault here. If you remove them, clean them up and make sure all is fitting well then your problem should disappear.

 

[MicKPM]

Unplug the brake fluid resevoir level sensor from the cap and take it for a drive. If the light stops replace the level sensor.

Also check you don't have brake pad wear lines as these catch on the inner arch and do the same.

 

[C2kev]

I have started getting this now but only on long left hand bends.....any ideas?

 

[RSprojects]

same issue here!

 

[Tony Hunter]

Long left hand bends is usually fluid level.

 

[C2kev]

Long left hand bends is usually fluid level.

Really? Cheers I'll go check and report back

 

[C2kev]

Well it was very low so hopefully sorted now

 

[Tony Hunter]

Well it was very low so hopefully sorted now

 

[danward]

Well it was very low so hopefully sorted now

Tony gave the same advice when I made a thread and was spot on.

 

[.J.a.m.e.s.]

left hand bends is exaclty my issue

 

[Tony Hunter]

There you go then.