tools required for whiteline arb fitting???

[yeecup]

going to attempt to fit this myself over the weekend, what tools are required? just a standard socket set? i presume its best to put the rear up on axle stands? is it an easy job?

 

[JackJack]

Yea axle stands are ok, just sockets needed afaik fairly simple to do from what I've read.

 

[jenic]

Socket set, spanner set and ratchet spanners come in handy too.

You'd be better reversing onto car ramps than using axle stands.

 

[ScarySquirrel]

A strong bar will probably be required in order to undo the shock bolts if they've not been touched for a while.

I'll also be fitting my ARB this weekend

 

[Tigger]

What about an impact wrench?

 

[aucky]

Socket set, spanner set and ratchet spanners come in handy too.

You'd be better reversing onto car ramps than using axle stands.

Yep. Keep the wheels on the floor.

I reversed mine onto a row of bricks..

 

[ScarySquirrel]

Can you not just put the rear on axle stands and then use a jack to lift the beam up to the right height? I only ask as I don't have ramps, nor a supply of bricks.

 

[yeecup]

iv got ramps, so is it easier to remove bolts etc if the wheels are on a set of ramps rather than hanging if u used axle stands? struts were replaced a few months ago so bolts should be ok to remove.