Tortion Bar>>

[Siggsy]

Ive just booked my valver into have its tortion bar droped next week...

Ive got the front lowered 35mm should the back be the same or a little lower...

Cheers Siggsy

 

[Rajk]

how much does it cost

 

[Tom]

nothing if you do it your self (its not hard)

 

[Ben H]

LPO - low power output?

I think it is hard to do - it depends on whether your torsion bar bolts are seized after all them years and how successful you are in fabricating tool to draw them out.

 

[Ben P]

Tool is very very easy.

Just an M10 nut and bolt through a 1/2" drive socket (think it was 27mm)

If you spray loads of wd40 into each end, drive around for a week and repeat they should come out no bother. Mine slid straight out.

 

[Rasclart]

I done mine as soon as I bought it. It was A f**kING PIG!!!!!!!!!!

Took for ever to get the bolts undone. I would pay someone to do it mate. Isnt that expensive and if something goes wrong have come back. Nothing worse than trying and spending ages, and not get anywhere.

Just my opionion mate! Having done my Valver wouldnt want to again!