Urgent 4 point Harness Fitment Help !!!!

[finch wxm]

I have some sparco seats , subframes and sidemounts.

I also have sparco 4 point harnesses.

The problem is i dont know where to bolt my harnesses.

I realise the rear of harness needs to be bolted where the rear bench was but where do i bolt the other two parts of the harnesses ?

There one threaded hole on the subframe sidemount but there isnt one other side of the subframe ?

Any ideas ? What has everyone else done ?

 

[HrRACING]

You need to drill a hole through the floor and use a stress plate behind to bolt the harness eye into.

They need to be fitted in a rearward direction from the holes in the seat, so they are pulling you back into the seat. If you need any stress plates etc send me a PM.

Cheers

 

[finch wxm]

Thanks mate I will pop into Demon Thieves tommorow to see if they have any if not i will give you a shout.

Does the stress plate go under the chasis and the bolt through the top of the floor plan ?

cheers mike

 

[mr.pink87]

or you bolt the outer harness strap to the oem seatbelt mounting hole at the bottom of the b-pillar. motorsports-gurus might hate, but this is an easy way and is safe! (harnesses with TÜV-approval are mounted as stated, so can´t be unsafe.)

 

[finch wxm]

Yeah ive bolted the outer to the OEM mount Mr pink, its just for the two insides ones, got 2 trs stress plates and a green TRS tow strap :approve:

 

[finch wxm]

Do you have to take the exhaust off and heat shield to drill the 2 holes into the chassis. I was going to drill two holes into the exhaust channel but obviously to fit the stress plates underneath ?