vibe cbr10 help

[garratt90]

Hi ive got a vibe cbr10. Just wondering what is the best option to put phase and gain on?

I have a kenwood kdc-w707 headunit.

Also just wondering what the output plugs on the actual sub are for? can i link another amp to this for my speakers?

Also isit ok to split the remote lead and split the power lead into two for another amp?

My wiring kit suports up to 2000W and my sub is only 1300W.

Thanks for ur help!

 

[Skinny]

Set the phase to 0

Set the gain a bit below half way. Do you know the Voltage output of the HU?

The RCA out on the sub is to link it to another amp. Better to use outputs on HU though.

Yes just daisychain the remote that is fine, from one amp to the other

The power and ground you need to split before the amps, ie. 1 cable in to out. This can be done using a fused distribution block for the power and either 2 cables depending where you grounded the amps or just a distribution block.

Does the amp have a hpf?/Lpf?

 

[garratt90]

http://www.justkenwood.co.uk/stock01/kdcw707.asp that is the headunit i have..

yer i have two rcas on my headunit so i will use the other one which isnt being used atm.

i havent brought another amp yet, im looking atm, any recommendations?

Thanks

 

[Skinny]

The hu is 2.5 volt, so set it between 0 and 4V on the gain, im assuming 4 is midway so around 1/3

Erm what do you want to run off the other amp? Speaker wise, and what are the speakers?

 

[garratt90]

ive got some 260w fusion 6x9s

and some Alpine SXE-1325S 13cm Speakers in the front.

thanks alot for ur help!

 

[Skinny]

hmm u need a 4channel amp really, maybe 100rms per channel.

Go on www.talkaudio.co.uk

As well as being a really useful site there is a classifieds with loads of stuff for sale, can get some real bargains.

A lot of people feel 6x9's are a waste of time. Have a search on there about them as well i cba to type it all out. There are many mixed opinions.

 

[garratt90]

ok thanks mate