Havnt done a clio one but have done plenty others,i use a large socket same size as bearing outer edge to push out and push new one in,make sure you have removed circlip if theres one fitted and put it in the right way up(some fit either way)just common sense reallyI have got access to a press, it's just the process of getting the old one out and pressing the new one in I need clarifying.
Thanks
Would it not be cheaper to replace the discs?
Would it not be cheaper to replace the discs?
if your not very handy with a grinder you can get it stinking hot and smash it off with a hammer and chisel !!
i never press the bearings out of front hubs, always scared of bending/snapping them, i smash out the insides the weld up the race then tap it out with a chisel, they press in a lot easier too