Fitting Rear Stub Axel Spacers

[t90_lle]

Just going to fit my stub axels spacer and hoping people could just confirm as it’s been about 3 years since I last did this...
Undo 2x Caliper bolts an move out of way...

Undo hub nut nyloc and remove disc giving access to 4x t50 torx heads...

Finally undo the nuts whilst holding the t50s not the other way round...

I know the hub nut is 175nm can anyone please confirm the caliper and axel bolts torque please also?
Thanks

 

[JamesBryan]

The smaller M8 bolt is 29nm and the M10's are 57nm.

100nm for the big caliper to axle bolts.

 

[t90_lle]

The smaller M8 bolt is 29nm and the M10's are 57nm.

100nm for the big caliper to axle bolts.

Brilliant and the above order is correct yeah?
isn’t there two washers/spacers behind the disc?

 

[JamesBryan]

Brilliant and the above order is correct yeah?
isn’t there two washers/spacers behind the disc?

Yeah sounds about right.

Just one washer behind the disc, it has a concave side and a flat side.

Flat side faces the disc.

 

[MLB]

I believe they're T40, but yeah best to avoid undoing them from the front if you can..