Recent content by Andi-B

Some of the O2 Cells are down, apparently from a good source of mine, dependant on which 'cell' your phone is registered to, depends on if you have signal or not. Sat in the same room as the better half, both on O2, I've had no problems at all and she's had no signal all day.

If he's crossed a junction when he should've stopped and she had right of way then it's his blame, no one else's. Hope no one was injured.

Horses arse... Seriously though, Horses can be temperamental at the best of times.. As for Kate, Wuthering Heights is a good song.. And not called 'Heathcliff' like some bint tried to tell me it was called a few weeks back.

If they ring again.. Tell them to do it, then...

That looks uglier than my dead grandma.. On the plus side, if it snows it can clear the road and the owner can throw grit out the back.

All the cars in the New Car dealerships are Premium, The cars in the used car dealership are standard, there's an "S" icon that explains this.. Also, if your unsure of the cars you've already bought, in your garage menu it lists them in different Standard/Premium menus..

I have 3 PS3's under my bed.. It's a real pain in the arse trying to keep them all updated. ;) Seriously though, I'm slowly getting fed up of the numerous updates, last one was only so it could put a few new added icons in the XMB menu and a warning for epilepsy when you switch it on.. Besides...

Standard.. (Besides Silvervisions, Head unit and HID Xenons.)

Re: Headlight lacquer on your 1*2 gone a bit "funny" ? very impressed with this ki Can see the difference between the first and last picture.. Looks a lot cleaner.

You forgot the drill/sander head for getting all the scratches out the paintwork, highly recommended.. Half arsed detailing job indeed. ;)

Add a *power resister.. It'll give you 20 BHP more and then you can really be the king of the road and be the best with a car like that. *This comment is just sarcasm, my official answer is you need to be banned from driving and it taken off you as punishment for your crime against...

Solder is ok IMO, Better than crimping as you've broken the rubber sheath and water could get in and rust the metal strands.. Use a higher wattage setting based iron as the solder stays more 'fluid' longer, so you can move it about more if you make a mistake and want to clean it up easier. Heat...

All on red.. Seriously though, couple of hundred? Save it for when/if you need it.

What's wrong with HID's on non-RS's? If done right and in OEM Xenon headlamps they look fine. Aftermarket sets look a little gash though.

All they are is just pieces of flat plastic to cover up the hole they leave. Like these on the 182 cup bumper pictured below. *picture taken from Auto Express website