Recent content by benkay

If you just take the sticky layer off, is the underlying layer fine on its own? Every guide I’ve seen they end up painting and lacquering the underlying plastic.

Anyone know what the centre dash bit is called, the sort of rubbery surround that includes the top "tray", then comes down around the clock and air vents? is that a separate part to the dash itself? Did the basic Clios also have a non-sticky version of that?

Hi all, The door pulls (and to be honest almost all the soft-touch plastics like the clock surround, hazard panel, ac panel etc) are getting pretty bad...despite almost never getting hammered by UV, I guess it's just an age thing! The door pulls are so bad that my fingerprints show on them...

So for anyone looking in the future. In my specific case it turned out to be the Airbag ECU. No idea why, no sign of anything on the unit itself. Perhaps a dry solder joint or something? Replacing the Airbag ECU and programming it in to suit fixed the issue and airbag lines show sensible...

Where are you seeing that? Ignore this, just seen the PDF download.

Anybody know where "E2" - Earth position 2 is on the car?

Hi All, I've got an issue with an airbag + Service light showing. I have Clip and have connected it to analyse the airbag ECU. I have multiple errors that won't clear : Code 74 - front airbag circuit 2, passenger open circuit Code 65 - front seat position sensor circuit, driver short to...

I've done a day with Car Limits in the V6. Highly recommended.

I think the micro switch is there so that if you sit really close to the wheel (like most women let's face it) then the airbag doesn't deploy with 100% force.

Nice one Lulu! (The cars called Lulu by the way [emoji18]) And well done yourself :)

What electrical gremlins are you having Jack?

Love this car, spent so much time on it (especially the full interior conversion, never again). It had a roll cage and harnesses in it when it left my ownership! You should also sort the brake ducts, there's pipes on the back, but no hole through the arch liners, was going to do it but car sold...

Hi lads, Thanks for your advice, in reality most of time spent will be gaming, so think I'm going to go the Z170 route with a 6700K. Other than the built in water-cooling block, anyone know the difference between ASUS Maximus Hero and Formula versions?

Can anyone give me a bit of advice re my question above? Also in either x99 or z170 what is considered the best ATX motherboard? Or eatx which will fit in a Phanteks Evolv case (264 wide max)? Thanks. So much to get head around! Sent from my iPad using Tapatalk

Hi guys. Been out of the PM scene for a good few years but looking to build up a machine shortly. I'm really unsure between x99 or z170. Machine will mainly be used for gaming, but also some 3D modelling, rendering etc. Money's not really a factor, but I'd like to go with the motherboard...