Search results

Individual

Overclocking the FSB also increases the memory speeds, correct? What effects does this have on the memory? Ie temps reliability speed etc etc... Thanks

You could have got a respray for £150.... Very good job, but overpriced

Yeah I agree with all that, depends how long your going to keep the car for too :)

sent.

Without expensive equipment and a lab to do seperate tests on your not going to get an accurate review. You wont personally notice a difference from one oil to another Comma is fine though used them before for my gearbox oil and engine oil/

Tef: that will fit yours as per the add lol.

I managed to get the spec of myPCIE slot, Logic would tell me the ATI card should be fine, but before I order away if someone could just confirm :D Thanks Bus PCI-Express : Device : C51 PCIe Bridge Version : 1.0 Port : 0 Physical Slot : #0 Slot Populated : Yes Link Width : x16 (max...

Try a glass polish as suggested, if not you can always go down the pikake and hammer route Or scrappy, but I find it hard to believe engine degreaser did that, what specifically was it?

Why does the brake fluid look like ribena? lol

To be honest Mark we all know you dont f**k about so do the right thing get a 45deg pipe stick the battery in the boot relocate the airbox & have the hole pointing towards the headlight area, no CAF required. don't think youl gain anything on an RR from just a panel filter, but we will see

I wouldn't say it was a bargain lol

Yep! Evo would be a better bet :cool:

Cool thanks for the linky, I'll have a uganda

I saw that on another website actually but I wouldnt have thought it would get equal distribution between the 2 components, I'll do some tests and see which one provides the best result at 100% CPU usage Thanks for the advice though Its a dual core AMD yep

I have lapped both the CPU and HS, upto 1200 grit (no point going finer than this) I have some of this http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=150271030496 Any good? My plan was to apply it thinly with my finger (inside a bag) then wipe both surfaces off with a MF towel...

250ftlbs of torque isnt going to happen without ze boost I'm afraid (ignore me I'm a pen15 I thought you put ft pound not nm) 230hp will be achievable I guess but thats about your limit sticking na 250NM is 184.37Ft/lbs so should get near enough to that around 175

Lol @ cheapskate I took mine out, does that make me a peasent? :(

The bottoms different for sure not too sure about the top. Breathers different between 172 and 182 but not sure about the old 172 vs new.

Thanks everyone :)