Search results

Don there is a little wire pin clip thing pull it out then tap the retaining plate towards you once out pull the pads out of the carrier noting which way the springs on the pads are located. Also wind the piston clockwise with a flat head screwdriver. The inner pads have a notch on them make...

Just need to give it a good polish now;)

Timing belts gone

Unlock code is needed some maps can vary from car to car. 182-182 should be fine but don't hold me too it lol. Have used my map on a few cars.

Change the cts and thermostat or just burn it!!!

I wouldn't bother either!

Wait till it gets to level then pull the wire out the back of the adjuster on the headlight ;)

I paid £310 for mine that was 5 wheels and tyres then £250 to refurb them Here is some pics 16" though http://www.cliosport.net/forum/showthread.php?655513-Clio-in-habberly-valley

Definatly the wrong bearing in the disc as 172,182 and dci share the same stub axle setup so doubt it that the stub axles will be wrong!

Will be fine as long as it doesn't sound like its trying to escape

Connect Rs tuner to the car etc RS about unlock vci put in code henk sent Job done, it may ask you to manualy type the vin number in off the car if not don't worry click read ecu it takes about 20mins to do it make sure the laptop is plugged in and car battery is in good health click read...

I would put winter tyres on the turinis;)

You can also undo both shock but leave the bottom bolt in and pivot the hub towards you

s**t

http://www.cliosport.net/forum/showthread.php?276833-172-182-buyers-guide ;)

nice

One between the mount and box and the other under the bolt

Renault, and he can get parts very cheap

Very nice

looks good!! because its different, Good job

http://www.cliosport.net/content/guides/Renault%20Sport%20Clio%20Guide.pdf

Remove the centre silencer and replace it for the straight through pipe

Goodbye

call 01902 439264 ask to speak to Adam

Check that this is still connected and isn't seized up spray it with wd-40, also unplug the plug on the other side and give it some wd-40 too. Its on the rear beam

:butt:

TCR in wednesbury

Clio-launch control-why

Connect RStuner Click on rs about logo (top right of the screen) Click unlock VCI Take note of the long number (or take a screen shot) purchase unlock code and at checkout put the long code in order comments. (in your case email henk back with a screen shot or long number with you're name and...

Good choice Chris!!! very easy to fit