Search results

Wet after you've washed it.

Turning the PC off at the wall shuts it down faster. Tune in next week for more quick tips.

It's good stuff. Requires the first application to be spread on with a damp microfibre (although I do this for every application with Gyeon Wet Coat)

Possibly, or might have been the quick release adaptor in the snow foam lance that I said to do. Where else was it leaking from, I couldn't quite tell from the picture. Is it where the hose goes into it? O ring maybe.

Take the adaptor out of the gun and PTFE tape the brass thread a load and try that.

Renault Parts Direct Not the cheapest but they are decent quality and come with the rubber seal.

May as well change your thermostat while you're there considering you're going to lose a bit of coolant.

They only have 2 wires mate, the green is just blank.

Japanese car mods. Used to see earthing kits everywhere back in the day 😅

What's the green wire at the battery, an extra earth?

Think i paid about £200 ish labour 5 years ago, plus parts. £400 doesn't sound bad.

Clutch, stick it in 4th or 5th at 2000rpm and floor it. Revs will rise but the car won't accelerate if it's slipping. Don't really hear of clutch slipping on these tbh, not got that much torque 😂

The other possibility is the seal around the heater box in the centre of the scuttle, water could get in there if it's perished.

I think people are expecting a bit much from a set of £40 pads to go out and do a track session on 😅 If it hasn't got DS Performance or High Carbon in the name, then it's not the premium Brembo stuff.

No they have a cheaper line made for them by Brembo. People often think they're getting the performance line of the usual Brembo stuff when it's not.

I don't run the discs because they're not the high carbon version. But on the road I would have no issues.

Also, I think Euro approach Brembo to make a cheaper line of products, rather than licensing the name to have stuff made else where. So Brembo will just use less quality materials to reflect the price.

I run Brembo pads from Euro on the road. Nothing wrong with them 🤔

Depends how much bedding in you want to do, some are more picky than others. PBS are good value and last a while, but not a lot of initial bite. Fairly long bed in procedure. Winmax W5 are better than PBS but considerably more expensive. I'd probably go for W6 if spending that much. Bed in...

Aye it's mad at the minute.

Because you're Wurth it 😂 Yeah i know it's pronounced wert

Nah they're decent for solvents. They don't like acetone and things of that type though.

They're all pretty much the same these days. but Gyeon Wet Coat is my go to.

Wurth 😅 Had it probably close to 10 years, still going strong.

I seem to remember it being a bit tight and yeah it bottoms out before touching the spring clip, I think I just left mine off 🤔 Not had any issues yet.

Scuttle drains are the first place to look to see if they're blocked up. Wipers off, trim off and stick a rod down all 3. Left, right and centre.

Not druids, that has a fence and trees infield. It's 100% Anglesey, if the picture in the OP isn't a decoy.

That's Anglesey turn 2.

Yeah it'll be fine.

3.1 but never get it all out/in. More like 2.8 that I get in usually.