Search results

I'm not much help, but u cn get the same code reader from beatthegarage for £20

The red cable that goes into parrot box needs to be constant 12v, the orange needs to be switched 12v. The earth is the black cable. If you hook both up to constant live the kit will not go off. The mk3 stereo is CAN and the parrot will only go off in sync with stereo if you get CAN adapter...

If u wire both to constant feed u will destroy parrot blue box in a short time- not designed to be run this way

Never realised u had mk3 presumed, as alistair says ignition feed will be required- easiest bet is to tap of cig lighter with scotch lock, or get some spur fuses and tap into fuse box, easy

Took bumper off and turns out the hose was jammed behind grille after the garage had the bumper off last, so after routing it properly the washers both work fine now, roll on the MOT ;)

Thanks James

Guy at local dealers quoted £3.40, told him he must have wrong part and I would call back - anyone got a part no for these (driver side)

Standard ISO wiring, may have to change the red/orange on parrot for ignition feed/constant supply so screen says 'goodbye' when key out, best place to mount box is behind carpet at centre consol side in passenger footwell, it's a pain to get all the wiring behind stereo but can be done, most...

Yeh looks like thts going to be the answer, due to lack of replies and search hits there's no mention of fixing the nozzle unless leaking, will get one ordered up tomorrow. Had the bumper off before when a ballast died, sore placed and siliconed both. Presume the washer is just held on with a...

Can u not get some 3mm Perspex and bond it on round edges? Never had a problem with mine tbh

Sometimes it may flash up where mileage is then have a series of dots, this will appear when oil is low- not as extereme as oil light coming on when u have to stop, but I'd check oil levels if they're low then there's ur answer- else wise could be a faulty sensor

Not a top hit on search bar so new post :) Got a faulty xenon washer, where the divers side won't squirt. Had pump replaced not long ago and passenger side works so know that's all good- so must be the washer part. Quite happy to take bumper off an fix if there's a way of fixing these...

No fuses for speakers, did swap speakers over to test? Generally it will either be a broken cable @ door jamb, or loose cable behind stereo which would cause such a fault.

If panel filter probably won't make much difference imo, but cones where increased air intake will lessen mpg

Also mines was around 80-85k at the time, not sure if that makes any difference

Mines made a squealing noise, started off infrequent the over time got worse, turned out to be power steering pump. Took it to a specialist as I was clueless and it was diagnosed straight away with bonnet up/ turning wheels. (I think, could be wrong) that since it was knackered the belt was...

Cnt answer question directly but remembered I'd seen a similar post not so long ago, by the looks of it u need to get seat with new airbag & airbag module then clip to reset ecu, link to thread below for some light reading until someone can give definitive answer...

H7

I once tried to fit a parrot kit in a 2010- Renault van of some sort, for a guy that wanted Bluetooth and sat nav wouldn't work. Then tried changing stereo and still wouldn't work, so cldnt fit anything to vehicle. A phone call to Renault resulted in them saying that the sat nav is reliant on...

If there's any residue left after decal comes off use 'sticky stuff remover'- iirc £5 from Halfords, helped a mate remove vinyl from a van in no time, stuffs magic

Is this a factory or aftermarket radio?

It's a mk3, id b going to an independent autospark and getting a price if it was me

Pop them in the oven, as long as u heat them long enough and the seals soft u can't really damage it, unless u try to prise apart with a brick

Abs ring

Ahh ha - http://www.cliosport.net/forum/showthread.php?t=739762

I'm sure I seen thread recently about a bit u twist in xenon lamp to change angle- cheaper than new lamp

I'll check my manual when I'm out in the car, will post back when u get home (approx 1hour)

The one u linked is right bt no need for the harness as it's ISO in a passat

Looks like it's for a light of some sort

Hope you've allowed the ballast/ ignitors to discharge first- otherwise you could get a shock. Once you twist and pull the ignitors off, there is a wire clip that holds the bulb in place, you need to release this then bulb will come out. Much easier with bumper off (only takes 5-10mins for...