Search results

Front and rear are the same, offset. Anyone had the Ultra ones?

Nice find mate. Do these fit in standard sized garages?

Mine isn't as bad as that but has been sitting a 1-1/2 bar lower than the middle recently. Could this be due to the colder weather?

I bought a set of 15's with the intention of putting some Winter tyres on them, however will just put some decent normal ones on instead. Managed to get stranded a few times last year but for the sake of a couple of days I don't see the point.

Re: Droning noise coming from wheel when moving * Correction * price to replace my front bearing was £100

I need a washer to go on my washer now lol

Re: Droning noise coming from wheel when moving Suppose so... Also bearings are more expensive if you have cup packs, didn't realise they used different ones.

Re: Droning noise coming from wheel when moving Cost £110 :dapprove:

Re: Droning noise coming from wheel when moving When I phoned to book it in he suggested it was the wheel bearing from my description. Took it in and they done quick road test and confirmed the noise was coming from the front. He then got one of the guys to jack it up to check, missed what he...

No more xbox :(

Spotted this in the car park outside Sports Direct, had private plate on but can't remember it

Re: Droning noise coming from wheel when moving Got mine sorted today, was my front near side wheel bearing. All good now, although my wallets feels lighter.

Hidden p**n collection? ;)

Agree with the above. Seeing as how this is your track toy avoid the Racelands, if you want something cheap go for the sportlines/whiteline arb combo. Also get a project thread going. Civic sounded good btw :approve:

The one I linked is what I got for mine mate

Also add some high temp silicone to the list of things needed

Hindsight would have save me loads of £££...

Post to: Europe, Asia, Australia Bet that will cost a fair bit

I had the the Super Sports (straight through) but changed the centre to the silenced version last week. With the silenced centre it is very quiet, too quiet in fact so will probably end up putting the straight through back on once the weather clears up a bit.

lol did you wear a short sleeve t-shirt over a long sleeve tshirt while you were doing it as well :rasp: Fogs will get chipped anyway due to their position anyway so I see your point. Cool just need start taking all the bits off to get sprayed, just can't be bothered to do it cause it's...

Would recommend a puller to get the wipers off, drivers side took a bit of work to get off on mine. Both pumps are the same and push fit into a rubber seal on the water tank...

Front and rear screens work off the same pump mate

It's classed as a sealant, wax can be used on top of it but not required.

You might see me about then, I work in Greenock :dapprove:

I checked mine by taking the pipe of and blowing through it

Sounds like issue with your pump, it's the same pump for front and rear windows, not sure why it would just decide to change though :S

There are 2 pumps, one for the windscreen and one for the headlight washers so you can swap these around to check if they are working. There is a 'fix' somewhere on here about trimming the rubber bung in the washer motor but for the sake of £5 I just replaced the motor. Most difficult part...

Got a can of satin black here to do the bits of my trim too, did you not primer before?

Welcome. About a tenner or so for the headlight washer from Renault. Just a bolt that holds it on so easy to fit.

Set of alloys, exhaust centre section, bullets and various other badges. Should really put them in the garage...