This is a sample guest message. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Did this today following the guide, i must say what a difference it has made! Clutch no longer creaks and it a lot, lot smoother. Only problem i had was getting the rubber gator seated properly afterwards. This is a great (temporary?) fix!!!
All the image attachments from the guide seem to be dead..
does anyone have images showing the location of the release bearing/parts that i should be spraying?
i have a 1.6 16v and the clutch cable ends near the front of the engine, i can see a fork with rubber boot which is pulled by the clutch cable, is this as simple as pulling the rubber off then spraying into gap? or am i way off?
Tryed some lithium spray greese, lasted about a day,so i had nothing to lose and used some wd40 and it lasted about a week. I don't really no what to do now. The cars very low milage so the clutch shouldn't be worn.
well if there's a squeak maybe we should find some type of grease that lasts more than a couple of days. let the search begin..
so, lithium spray grease doesn't work (you did spray in the areas mentioned by the OP right?)
I can't cope with mine, it's horrible to pull away with aswell as the creek!! It's almost impossible to get a smooth pull away. Could be the pressure plate fucked but after a spray with lube it's all good for a few days so..... I just don't no