172 ph1 flywheel question

[vjs]

As I was unhappy with the slippy LUK clutch was to change it back to Valeo. When I was going with a LUK clutch 3 moths ago all the mounting job was done in a garage and I think chap whom did this job did not give a sh*t on what condition flywheel surface is.
When I removed LUK clutch by myself I got flywheel surface was rough as how to say kind of small waves on a surface.
What should I do in this situation? May I get it polished or?
Any info would be appreciated.

 

[Gray]

Have the flywheel skimmed.

 

[vjs]

Have the flywheel skimmed.

No ideas. How to get it was it or not?

 

[Dan519]

Remove the flywheel
Take it to an engine reconditioner/machinist
​Ask for it to be re-faced

 

[Gray]

Remove the flywheel
Take it to an engine reconditioner/machinist
​Ask for it to be re-faced

This.

 

[vjs]

that's what exactly I was going to do. Just checked if You have some knowledge on this this is my first car I got my hands on and for me everything is new. It was quite time to get to the clutch.
Seriously speaking thank You for an info.

 

[Andyman]

Is it ok to reuse the old flywheel bolts or should they replaced?

 

[GrahamS]

Get a TTV racing one

 

[Gray]

Is it ok to reuse the old flywheel bolts or should they replaced?

You should replace them.