Bolt sheard on inlet manifold

[RichMcc]

I was about to take my inlet manifold off and where the two sections of the manifold meet one of the rear heads broke off the moment I tried to untighten it.
Theres a chunk of the threads left poking out of the top and loads poking out below but I cant get to that.
How the heck can I get it out? I dont fancy drilling it because I dont have a thread cutter.

I was thinking of drilling the top off the threads and trying to thread anotehr bolt through to push the other one out, would that work?

 

[gunnergibson]

use a dremel an cut a notch for a flat head screw driver

 

[len_beach]

Spot weld another bolt onto the thread if you have access.

 

[Jones]

^^^^ sod that get a pair of mole grips on it much easier just dont chew it up to much, it should come out really easily