Cup Splitter.

[Lee-182]

Got this at FCS, Think I got my pants pulled down over the price, for some reason i thought the K-Tec one was more money, Does it look right? why is there some bits cut out and some not?

Where do i put the screws? and do i have to pilot hole the bumper?

Its also printed with "Car Styling" "Made in Belguim" (sp) Is is def a geniune Renault Part?

 

[Lee-182]

Think im gona tiger seal it, let it dry then screw it. Gona e a c**t with just me to do it

 

[jesus]

I held mine in place on the bumper with clamps, drilled holes through them both together and just used self tappers. Did about 6 holes/screws.

 

[Lee-182]

Dunno how im gona get it up high enough to get a drill in there. Hummmm

 

[jesus]

A jack might help?

 

[Lee-182]

i only have the one with the car, not sure if i could get enough height

 

[Reyes]

Drill it in.
Looks genuine.

 

[jesus]

You only need to raise the body up a little bit, I did mine without anything (although it wasn't lowered at the time...).

 

[shadowsun]

Yeah, looking like the offical renault one. There are no holes in it when you buy it. As said, you drill it and it should come with 9 self tapping screws - but you can just get those from Homebase.

 

[Reyes]

You only need to raise the body up a little bit, I did mine without anything (although it wasn't lowered at the time...).

+1
I only jacked the front end and used a kurb to do the rest.

 

[TimR26]

I was looking for a splitter must have got there before me. Which stall was it on?

 

[Dangerous_dave]

how mucho did you pay for it?