Everything that could have went wrong did, pics inside!

[clio_dude]

Hello,

This is my second attempt at this as my pc died the first time...

Today i thought i would lower and fit my new discs/pads to my valver, simple i thought. After lowering the rear end i let the jack down, but as i pulled the jack out i caught a fuel line and ended up with fuel everywhere.

I jacked the car back up to investigate, i had snapped a bit of plastic off a part so there was no fixing it. I phoned my local stealer with the part number, he told me he couldn't find it but he'll have a look on the system for me.

The part has two wires going into it and two rubber hoses. The details stamped on the side are:

7700811581

p=50KPa

Here are a few pictures:

Does anyone know what this is or does anyone have a spare?

I gave up with that so i tried fitting my ktec rear discs and EBC pads, shouldn't be a problem i thought. I got around to putting the discs and pads in but there isn't enough room, i have spread the cylinder as far as it will go. The top cap was off and i also tried loosening the bleed nipple. I also loosened the handbrake right off, about 5mm extra was needed to fit everything in. Any ideas?

I started with a working car and now i have no handbrake/foot brake, no fuel etc.

Any help would be appreciated :dapprove:

 

[bmh.01]

You did wind the rear calipers in yes? Not just push them in?

I think (although i'm no Mk1 man) thats the aux fuel pump not 100% though.

 

[clio_dude]

Wind? They twist in and out don't they

 

[bmh.01]

To get them to go back when fitting new discs/pads you turn the piston clockwise to wind it back into the caliper, you did this yeah?

 

[geesus69]

sounds like you have been sent or ordered the wrong pads there, i had the same trouble with a set which turned out to be for an rsi iirc

unless as above you haven't wound the piston back in fully

 

[clio_dude]

I didn't realise it needed to be winded in... thanks!

 

[mattjk]

Easy with a G-Clamp.

 

[Gaz_]

Worries me people workin on their own cars with not much know how........

 

[jayxx83]

cba nowadys, so much cheap labour out there. had one garage quote £140 to fit front discs and pads!! took it round the corner and £30 while i waited had it sorted!

 

[clio_dude]

Any ideas what the part is?

 

[davebem]

Im not sure either, looks like a pump. Whats your cars fabrication number, ill look on dialogies.

 

[clio_dude]

Does anyone on here have one of these for sale?

 

[16v_paddy]

Might be better off lookin on clio16valver.co.uk or williamsclio.co.uk
More mk1 stuff for sale on there, try askin matbrown or winston they're always breakin valvers