Help fitting omp boss kit 182 (help ASAP)

[182 al]

So I ordered a omp boss and wheel and it arrived today so I went out to fit it as thought it would be straight forward.
i have removed standard wheel and fitted the wires through the boss apart from cruise control as it does not fit.
when trying to slide boss on to the splines it does not go straight on.
so do I just apply more pressure to boss to fit on r have I done something wrong?
also wat do u with the c/c wire?

Thanks need help ASAP

 

[Scotty-boi]

I think the hole on the omp boss isn't big enough. I might be wrong.
Most people go with a momo boss. And it seems to work

 

[Kelv]

Ive used the OMP boss on two 182's now, no problem.
with the wiring, all i used was a file just to open up the hole a smidgen, it hardly needs anyhing, more just to remove the paint and general rough edges.

with the splines, have you ensured they are lined up correctly, there is a section that does not have splines on the steering shaft that should match the section within the boss!?

 

[182 al]

Did not notice that thanks for quick replys will try that and see how I get on
do u have to apply much pressure to get boos on are shud it go on freely?

 

[Kelv]

If lined up, it will almost fall into place.

remove the boss and look at the splined section inside it, then take a look at the splines around the end of the steering shaft, you will probably kick yourself for not spotting it

 

[182 al]

I did look lick an idiot now lol
thanks for your help just trying to file the hole now to get c/c wire through

 

[182 al]

Got the wheel fitted thanks for the help
just need to have a look at it again as after putting all together found that the airbag light cums on and horn does not work
so will have to make a new wire for the horn
read that u can use 3.3ohm resistor for airbag but do u put a resistor in each cable are just one to join the two together?
as connections with omp boss did nt work unless they r fitted wrong

 

[wilyoldave]

A resistor in each airbag plug - fold about 5-6mm over each end and then put into plug, then fold the resistor down flat onto the plug and tape it up to secure it all.

 

[Dan]

A resistor in each airbag plug - fold about 5-6mm over each end and then put into plug, then fold the resistor down flat onto the plug and tape it up to secure it all.

make sure you do that after putting it through the boss or else it may struggle to fit afterwards.