Installing a new steeringwheel

[CLIOHAL]

Can anyone give me the basics on how to remove the standard steeringwheel and how to install a new one.

Not to sure how i put the new one on. I think i need to pull of the middle bit of the wheel where the airbag is but i don't want to set it off.

If anyone can let me know how to do this, that would be great:lolup:

Regards,

:star: Cliohal:star:

 

[TheCake]

Sounds like we need a guide from someone who's done it

 

[Ad]

right the basics of what i did

1. Disconnect battery and leave for 30mins.

2. unscrew two torx screws at back of steering wheel.

3. disconnect airbag

4. untighten bolt on steering wheel.

5. bolt new boss kit on.

6 bolt new steering wheel on.

7. connect/wire horn (you dont have to bother with a ph quick)

really simple and straight forward

 

[craigp172cup]

i dont think there are torx screws on a clio ii

 

[Ad]

i dont think there are torx screws on a clio ii

I put good money on that there is...

they are down what looks like tunnels. Its impossible to actually see them matey.

 

[lemonnobby]

on ph1 there is on ph2 its clips.

 

[MR_PEA]

yeap clips on the ph2 clios. just push the clips outwards, it will release the airbag.

 

[craigp172cup]

cheers guys. just wanted to check before i burn my face off!!!

 

[CLIOHAL]

Thanks for the repllys peeps. Got my new steering wheel on the car now, looks sweet!

There are torx screws on the back of the steering wheel.

Thanks for the help!

:lolup: Cliohal:lolup:

 

[ditz]

what wheel is that, i want it !

 

[Renault_Boy01]

what is the gauge by the tweeter ????

 

[R20 CWH]

looks guid

 

[MT AUDIO]

knew it!!lol.looks good

p.s pioneer 85bt or 6900 by any chance?

 

[MR_PEA]

whats did you do with the air bag wires?

 

[CLIOHAL]

Sorry for the late reply. I got the wheel off of EBAY and it cost me only £30. Bargin! The airbag witres are just in the centre on the steering wheel, fit nice and neat in there.

the silver thing on the dash is a rev gauge and shift that i still need to wire up. I have tried to wire it up to the coil but the reading are all wrong. anyone know, let me know, it is a simple install by the look of it. 3 wires 1 for the signal, one for + and one for -. Just need to know where the signal one goes.

Thanks,

Cliohal