Loom removed to fit cage - refitted and now red immobiliser light lit

[len_beach]

As above, we removed the interior loom and dash to fit my roll cage. Now we've refitted it we are getting a red immobiliser light and no cranking.

The indicators at the back work also but not the front. Is this a UCH issue, have I missed plugging something on of is it something else?

 

[Lawro]

Did you unplug the UCH with the battery still connected?

Make sure the bolts on all 3 earths are connected under the windscreen (Left, Right and Centre), the 3 plugs are collected to the UCH and check the fuses.

 

[len_beach]

Did you unplug the UCH with the battery still connected?

Make sure the bolts on all 3 earths are connected under the windscreen (Left, Right and Centre), the 3 plugs are collected to the UCH and check the fuses.

The UCH was still connected to the loom but I'm not sure if the battery was disconnected when the multi plug was split. School boy error I know!

UCH plugs seem fine but ill check again and I'll check all fuses.

 

[MicKPM]

You really should plug it in to see what's got its knickers in a twist mate cos it could literally be anything from a poor connection to a blown unit.

Check the simple things first like earth's but honestly, clip time would be money will spent if you don't find anything obvious.

Mick

 

[len_beach]

I've just plugged my RSTuner in and it can't connect to the ECU.

 

[MicKPM]

Have you done any work in the engine bay?

 

[len_beach]

I removed the inlet manifold to swap the blower but the car ran after that. Not done anything since we did the loom.

 

[MicKPM]

If the car has climate have you plugged the panel back in?

 

[len_beach]

If the car has climate have you plugged the panel back in?

The panel is plugged back in but the time/temperature display isn't.

 

[cliosport200]

sounds like your ecu is fucked, i have a kit if you need it

 

[len_beach]

The bolt through the bulkhead pulling the two halves of the loom together wasn't tight enough. Doh!