Radio beeping noise

[Lucaio]

My radio has started to beep at me every few seconds when it's turned on. I have the tuner list radio, it may have something to do when I held down the SRC button and it went into some menu although I didn't change any of the settings there.
It only beeps when the radio is turned on, and it still beeps when I pause using the steering wheel controls.

Anyone have any idea what I have done and how to fix it?

 

[Lucaio]

Fixed.
If anyone gets a similar problem and wonders what to do....

Leave the radio on for a minute, then hold down 2 and 5 to get onto the code entry menu, then enter the radio code using the steering wheel controls (scrolly thing to change number, mode button for next), then hold down the mode button, select 2 for curve, hold mode button, select others, hold mode butter, set rear to on, hold mode button. And problem solved!

 

[Colink]

Fixed.
If anyone gets a similar problem and wonders what to do....

Leave the radio on for a minute, then hold down 2 and 5 to get onto the code entry menu, then enter the radio code using the steering wheel controls (scrolly thing to change number, mode button for next), then hold down the mode button, select 2 for curve, hold mode button, select others, hold mode butter, set rear to on, hold mode button. And problem solved!

14 years later, trying to resolve the same issue.
I have the code from the user manual.

Not sure how good your memory is!

I have followed the isnstrucions in this video

In the video holding the mode button stores the code and radio turns on.

When I do that I get “CODE” in the display and I have to turn the radio on. It continues to beep.

I assume I have wrong code but want to double check.

your steps seem a little different to video.

these two steps seem part of setting the 4 digits, but I don’t understand ”curve” and “rear to on”

select 2 for curve, hold mode button, select others, hold mode butter, set rear to on,

Your last step is hold mode button, same as video, but as stated above, holding mode displays “CODE” instead of turning radio on.

Suggestions?

 

[Colink]

14 years later, trying to resolve the same issue.
I have the code from the user manual.

Not sure how good your memory is!

I have followed the isnstrucions in this video

In the video holding the mode button stores the code and radio turns on.

When I do that I get “CODE” in the display and I have to turn the radio on. It continues to beep.

I assume I have wrong code but want to double check.

your steps seem a little different to video.

these two steps seem part of setting the 4 digits, but I don’t understand ”curve” and “rear to on”


Your last step is hold mode button, same as video, but as stated above, holding mode displays “CODE” instead of turning radio on.

Suggestions?

I took the radio out. New code on back. All OK now.

Regarding the two confusing steps.
curve, rear to on (also “other” are three more options that occur when final button press is shown in video (but not on video).
i assume these can be changed, I did not.
curve = no idea
rear on = I assume rear speakers
other “ geographic area for radio signal. UK and Europe = Other (I believe).
after final press of mode button radio came on