Rear suspension tower bolts

[wallisj]

Hi peeps

Is there anything special i need to do to remove the nuts from the rear suspension towers...i know on front i think an allen key way needed to hold it while the nut was removed....similar thing???

THanks for advice

Jamie

ps dont want to start another pros/cons debate on strut braces

 

[Fred@BTM]

You need either a small spanner or a pair of mole grips to hold the top spindle of the shaft, then you need one of those spanners with a hold in one end and open at the other (if you know what i mean, both ends the same size) and i "think" the size you need is 17mm

remember left lose, right tight!!!!



To losen them drivers side pull towards you, passenger side push away (i know this is obvious, but you should see some of my mates!!!)