steel tube

[ben_p]

hiya all i have been every where today after some 60mm steel tubing need about a half a metre of the stuff its for my custom induction i want stuff like this but not this kithttp://www.k-tecracing.com/show_product.asp?id=367http://www.k-tecracing.com/show_product.asp?id=367

 

[wareing172]

if you dont want stainless steel then you can buy it from most motor factors i think. used to work for unipart and it cost about 15 bucks for a 2 metre length when i was there.

 

[ben_p]

i need solid stuff lol

 

[Final Maxim]

hows the air gonna be sucked through?

 

[wareing172]

shouldve looked at the link 1st i think!!!!!! you can get solid steel bends like that from most major exhaust companies tho

 

[ben_p]

i got two samco elbo joints, just need the pipe will exhaust places have 60mm tube

 

[wareing172]

ye should do, alot of 4x4s have 60mm

 

[ben_p]

cheers mate, ill have a look tomoz any backup plans

 

[wareing172]

hmmmm! unfortunely not, but you should have no problems as long as you dont mind making a few calls. try any good motor factors or places like a.t.s, kwik fit (last choice) etc

 

[turbo16valve]

<<< has variouse off cuts of stainless tube at work... also got a pipe bender!

will check tomorow on sizes when i weld my gbox up!