stripped out valver - interior painting

[Adams_16v]

There is a lot of bare metal inside my car with it being stripped out all the time, and its the original colour of the car! so it looks a bit sh*te! Im planning on painting it all with hammeride black paint, but what finish would you recommend!

Smooth and shiny, satin, or matt black?????

the alloys, vent etc are all matt/satin black but i dunno if that would look ok inside the car!

Opinions welcomed! cheers

 

[cliosportcraig]

Id go for matt TBH the shiney hammerite is a bit too shiney

 

[McBunny]

wall paper bud its the future i have seen it !!!!!!

 

[northy]

Id go satin....Matt is a pain to clean if it gets marked

 

[Dust]

I was thinking about covering all mine with velvet like carpet? Just plain black. Nothing too expensive, just cheap stuff. Paintings an option but wont hide all the wires which are hanging about looking untidy?

 

[FlamingMonkey]

Id go with the Wallpaper idea, sounds like a plan, a good plan

 

[Adams_16v]

hmmm mi mums got some flowery wallpaper left over, might give it a go!

dont mind the wires too much, but there is also the fron t doors and everythin!

Iv got a fuel setup in teh back, and braided fuel lines running from the back through to the front of the car so carpet wont go down easy really without a lot of cutting and that!

Plus the bare metal looks more hardcore hehe

might go for the satin then paint!!

 

[PoloTwist]

Quote: Originally posted by Dust on 02 September 2004


I was thinking about covering all mine with velvet like carpet? Just plain black. Nothing too expensive, just cheap stuff. Paintings an option but wont hide all the wires which are hanging about looking untidy?

Only cheap stuff because Kamal isnt paying you? Get out of there Dust! He is being investigated left right and centre!