the little washer when you changing rear disks

[OLR]

When you change rear disks there a small washer that you put on the back to stop it from fauling on the abs sensor. does it matter which way you putit on???

 

[The Boosh!]

Yes it does IIRC. I have no idea which is the correct way though

 

[OLR]

thanks. DOES ANY ONE KNOW THIS!!!!!

 

[Fred@BTM]

yeah the side with the angle in the hole goes car side

 

[OLR]

so the flat part goes bearing side ?

 

[Fred@BTM]

put a pic up, its easier!

 

[Dan R]

I was gonna say make sure u get it right as they shatter so easily!! Both fell apart on mine when i replaced rear bearings

 

[Henry]

the bevelled inner circ faces inwards and the (slightly wider?) squared end faces out

 

[OLR]

This is with the angle bit facing up is this the right way???

 

[OLR]

the bevelled inner circ faces inwards and the (slightly wider?) squared end faces out

This is right just read it in the haynes manual