Torsion bar

[Lunner]

On the mk1 Clio, if i was to drop it by 2 notches, how easy is it to raise it back up if it was too low?

 

[Daz]

As easy as it was to drop it.

 

[Soneji]

Easier

 

[Essex_Lad]

y u raisin it? it scrubbin?

 

[Ben P]

I wouldnt think in terms of notches though mate.

When I lowered my mk1 clio you couldnt see the inside of the bracket, so I just had to raise arm by the amount I wanted to lower car by, then jiggle it a bit until torsion bar went in.

It is very easy though.

 

[Lunner]

I havent done anythign yet, tempted to lower by 60mm, but if its too low i want to be able to raise it again

 

[1fast6]

dont lower it by 60mm. it scrubs badly when there is more than 2 people in the back. sometimes when there is only 1 person.

i will show you on saturday, im planning to raise my t-bar soon as the rear arches are starting to split my tyres!!

 

[glenn]

you must have wrong offset wheels or wrong tyres. what you running mate?

 

[1fast6]

am using 16v phase 1 turbines with 195/45/15 rubber.

pretty much a standard setup, it should scrub but it does so it is goin up!

 

[Lunner]

Think i will have a go at lowering it myself with a m8 who is a trainee mecahanic, drop it 60mm and see wot happens if it rubs then i ca raise it again

Cheers for the advice guys

 

[Bubbles]

Lunner and RTvalver.. did you meet up today?