172 Cup
Haha Good effort! Hydraulic handbrake?
ClioSport.net
Register a free account today to become a member!
Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
-
When you purchase through links on our site, we may earn an affiliate commission. Read more here.
What have you done to your car today ???
- Thread starter pastieman
- Start date
Haha Good effort! Hydraulic handbrake?
Pauleds
ClioSport Club Member
Merc Dueliner sport
Standard handbrake which worked fine, I just did it a lot faster than normal and slid off.
Hello Paul,
Ha ha nice one, good result Sunday for you well done, I hope your only doing that on practice lol that place is lethal in those conditions.
Regards Russ.
FF 182
Ordered some TPI Polarized wheel bolts for it. Already have the brand new locking wheel bolts that i won on ebay for £0.99 
welshname
ClioSport Club Member
Fitted my missing exhaust clamp replacement. Can no longer see the exhaust hanging down
Clio Trophy
Taken my winter wheels off, and fitted my new speedlines, and shiney new center caps
View attachment 110227
View attachment 110228
View attachment 110227
View attachment 110228
Clio Trophy
Renault Clio 1.2 16v
given it a good clean
M2 Comp
got my 10mm rear spacers fitted -1 negative camber yo!!
cheers AlexW
cheers AlexW
Clio 182 FF
Cleaned seat belts.
Before
After
Jet wash? Did you removing them? If not how did you get them so clean?
Clio 182 and Boxster
Just soaked them in a solution of warm water and a some Vanish powder for a couple of hours, scrubbing with a nail brush every so often. Didn't completely remove them, just released them from bottom bracket, pulled them out as far as they would go and secured with a clothes peg.
Pauleds
ClioSport Club Member
Merc Dueliner sport
Is that the pioneer x6600 by any chance? I've just ordered one for my Clio. Any good? Looks nice.
Like the CS stickers! Good choice. Can you upload a pic of the full rear of your car? As I'm looking to fit Rs200 badge soon and don't know wether to leave Clio badge and fit the RS as you have. Or to fit new RS where Clio is. Cheers!
FF 182
Cat to manifold gasket fitted. Old one was well and truly knackered!
Range Rover Sport
FF 182
Just depends on what state your old bolts are in. All being well it's a 10 minute job. If you need some strength/heat/sawing/cutting it could take a little longer. A wire brush and some WD40 applied in the days running up to it would help.
pretty easy todo without a ramp, what i done is put a socket on with a ratchet and wedged it in place so it keeps pressure on the bolt then get underneath and add the washer then the spring then the other was plus the bit that sits around the spring then do the nut up fairly tight this will make it a lot easier doing the other one up then. thats how i've done it the last 3-4 times.
Inferno 182
Yes mate it is,£99.99 from halfords and we'll pleased with it. Change colours to suit the dash although I haven't tweaked the brightness yet. I put the DAB antenna on the side window as apparently the sun reflective screens on the Clio can block the signal a bit.
Be warned when you turn it on it says No Signal. Thought it was a DAB fault but you just need to scan through the different groups until it finds some.
Great with the USB as well,using a 32GB sandisk cruzer blade as do not stick out much and loads of music.
Will sort a picture tomorrow.
Be warned when you turn it on it says No Signal. Thought it was a DAB fault but you just need to scan through the different groups until it finds some.
Great with the USB as well,using a 32GB sandisk cruzer blade as do not stick out much and loads of music.
Will sort a picture tomorrow.
Replaced all my abs rings for the correct tooth.
Started work on the Red DCI as it failed the MOT. Neighbour came out at half 7 and complained I was banging too much at 11:30 this morning and that he hoped I wasn't going to be out late tonight working. He's lived there 2 weeks. I've lived here for 20 years :/
Anyway. I still got 2 ball joints on it replaced with the help of my mildly muted hammer.
Started work on the Red DCI as it failed the MOT. Neighbour came out at half 7 and complained I was banging too much at 11:30 this morning and that he hoped I wasn't going to be out late tonight working. He's lived there 2 weeks. I've lived here for 20 years :/
Anyway. I still got 2 ball joints on it replaced with the help of my mildly muted hammer.
Similar threads
