would this be ok for filling lambda hole

[domjolly]

just checking because i thinnk i have the right size m18x1.5mm bolt but this is to clean the thread but i was thinking surely it will stay in place! do you think this would work on filling the 2nd lambda hole on a decat?

 

[Budgie]

As long as the thread size is the same, it'll be fine..

 

[domjolly]

just need to confirm with someone thats the right size hole now lol cheers for the speed reply

 

[Jay Payne]

Just buy a lambda blanking bung! :S

 

[domjolly]

Just buy a lambda blanking bung! :S

tried searching for one mate dont no where to get them bit of a nOOb at all this lol

 

[Jay Payne]

I bought 2 this week, my local Partco hand them on the shlef and were less than £2.50 each with trade dscount.

Just looked on ebay and they are £10 with postage

Could try a local exhaust centre, they may have some or get you one no probs

 

[domjolly]

cool cheers mate ill just do that then! what size did you get to fill the hole?

 

[Jay Payne]

Just asked for a lambda sensor bung and it fitted. If all else fails go to a scrappy and get an old sensor to block the hole, just cut the wires off

 

[domjolly]

thanks for all the info!!!!

 

[Jay Payne]

No Probs

 

[Andyman]

Why do you need to fill the hole in ?

 

[Jay Payne]

he has a phase 1 with only 1 lambda sensor and a decat with 2 holes im guessing