Recent content by Chris.C

Definitely no teeth missing on passenger side, I've thoroughly cleaned and checked that side several times. The drivers side looked ok last time I checked but I haven't cleaned it as thorough as the other side so that's part of my plan today, cause for how much I've got the abs sensors for I'm...

Does anyone have any suggestions/opinions on this at all? Thanks

Oooops just realised, posted in the wrong section, can a mod move it to the faults section please :)

Hi everyone, Ok so bit if his history first. I had a abs fault about a month or so ago, plugged diagnostics in and had an unknown fault code, did a live data run and found the L/H abs sensor was reading a different speed to the other 3 sensors. So assumed it was the L/H sensor issue. Replaced...

Ahh that's great, I can't believe I missed that lol thanks dude :)

Anyone?

Yer it all went together ok, I cleaned up the hub where the sensor goes, and it defiantly went all the way in. As far as I can tell its fitted correctly though I haven't checked it against the other side actually, I noticed the passenger side sits about 5mm away from the ring, probably less...

Ok, so bit of history on the fault.... I had a slight issue on track a couple weeks back, wheel came off the hub slightly due to bolts unwinding themselves (I did check aswell before anyone comments, i checked after 15-20 mins of track and it was fine, wheel came off 2 hours later) I was lucky...

Dont mean to hijack but on yhe subject I was looking at the direzzas, and came across the Dunlop dz03g, their a 1b road legal tyre too. How do they compare has anyone ever used them?

Hi guys, Bought myself a stud and nut conversion the other day and got them fitted yesterday. Im on track tomorrow and donny (hope the weather holds out lol) and wondered what every one who has this kit or similar torques the nuts too? Do you just got with standard or a bit more? Then I've...

Finally managed to get some paint on the rocker cover, looks a lot tidier than before. Before.... After...... Bit unsure if to do the back of the rocker cover, the raised bit in black or leave it as it is?

The centre on the piper is essentially a sleeve fitment, but it comes with an adapter to fit an olive joint set up too. So really any decat will fit. But you'll be better off getting a sleeve type decat. Most sleeved ones will fit, ktec's one, milltek, and piper do have their own for the...

That's a good bit of feed back, I was looking to replace these with some p zeros I think when it comes to new tyres or something around that price, just a shame I don't do many miles so takes ages to wear down, unless I go for a few 'spirited' drives in them lol. These came with the car though...

Ill have to have. Look for any rubbing marks on fri when I swap onto my track wheels. Going to take it another place to get a free check to make sure it's all good with where the toe and camber is set and its all even I wouldn't say the tyres are 'cheap' to buy, they're about £80 a tyre...

See that's the thing mine isn't just low speed. It happens at higher speeds too. Went for a blast Sunday night and it squealed then too, when it didn't do that before either. Checked tyre pressures too and they seemed ok, was only 32psi each side. Meant to be about that standard isn't it?