Search results

How long have they been on there? They may come off they may not, they've a nasty habit of shearing off.

I'm assuming this is for laser generator cooling?

Roger Clark are just round the corner with a 4wd DD, keep meaning to go over for a run.

http://www.ebay.co.uk/itm/RENAULT-CLIO-LAGUNA-MEGANE-SCENIC-AIRBAG-ECU-SRS-MODULE-RESET-REPAIR-SERVICE-/111087099232?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item19dd4e9d60 Thank me later.

99.999% of people in the motor "trade" are c***s/incompetant. As well proved here.

All ph2s do, only the ph1 comes as bare plastic.

Where a outs on the sump? Very easy for it leaking out the pump to end up there. What pump was fitted? Cheap rubbish or Renault?

Never did like the OEM engine cover/filter arrangement, so decide to drop one of these on. Also got an R8 oil cap and R8 coil packs (they're red and pretty) in the post. Untitled by bmh.01, on Flickr Untitled by bmh.01, on Flickr Untitled by bmh.01, on Flickr Untitled by bmh.01, on...

It's the wrong manual and the wrong procedure, hence why I mentioned it. Will have to have a look through the mk2 ones but I don't know if they cover the qs5 box in detail.

Bear in mind that MR392 is for the Mk3 though.

Vdiag No: 14-18 SEQUENTIAL GEARBOX Fault finding - Replacement of components COMPUTER - (RE)PROGRAMMING 21B A) Switch on the ignition. B) Clear all programming using commands: – RZ002 Programming, – RZ003 Program biting point, – RZ008 Initial closed...

Nice to see one thats not ott chavtastic low, really like the B14s myself give a nice ride can really tell there a step above the cheap rubbish.

Stage 1 is usually circa 300-310 bhp. Need to get to a 4wd dyno to get an idea.

Similar idea, you can get a bluefin for them iirc. Its an obdii remote programming box that quite a few tuners use, it's made by an Italian company afaik and people just put their stickers on the front. It the exact same thing I had from RStuning for the Megane, except it takes about 15 minutes...

Fine not had any problems, performance increase as expected. It's pretty much as people report more progressive and less aggressive than the revo.

Thanks for that, very informative.

That £150 is just for the STS alone, it's still £395 for a map as well. Payed £558 all in delivered.

Some oophf in a box has arrived ;) Untitled by bmh.01, on Flickr

For as above £2k minimum, but you don't have to go that mad. Yes you could use a TV but it's not ideal unless you can still get close to it imo.

If its cup then it'll 110% be the speedo sensor, ecu uses the speed feed so not surprised it gets a little confused.

Alarm prep.

They're more hassle than they are worth and aren't worth a lot with modern equipment. As said unless everything that is connected is set to support jumbo frames the oversized (to other gear) ones will be getting dropped left/right/center/etc.

Turn off auto updating perhaps?

But the ecu won't be fuelling right. But that's not important of course because you don't rag it. They're like £15 ffs.

No s**t. Whichever dipstick serviced it hasn't put enough oil back in, looks well. And god only knows what oils been used.

MPH plasma dial kit and the speedo hasn't been converted. Simples.

I have. PM me if you want to sort something.

I've never had much success with the rubber multi fit ones personally. The proper sized plastic ones are much better imo.

UCH fault, replace.

Needs to be recalibrated with clip, it has a limited travel so no you can't just spin it round.