Search results

parts are like rocking horse shite also new parts a mega bucks the wheels need to be spaced out about 4 inches the vee is slightly longer so it wont look right on a 172.

ha ha

if everything went ok then 2k would be a reasonable figure .... what was you charged in total to fit all the stuff and replace the broken gearbox mark?

if you have fitted powerflex bushes get ready for the SQUEEK SQUEEK SQUEEK

been on the crack again son?

the guide is "dont bother unless you have a bucket of cash"

drums are fine and disks offer no better rear braking in a clio what so ever. drums come with other advantages like stronger bearings and lower cost replacements. the only reason to upgrade is for the thicker anti roll bar

6.5 wont be a problem the tyres will just bulge out a bit more. i know the roads are bad in oz so stick with a 50 profile tyre

dash, loom, all the shitty relays and fuses they come with, airbags, steering wheel :dead: if you need air bag.

magnex are pretty bad exhausts id go for a custom jobbie or a yozzasport ragnoti for sound. prospeed in cardiff will do you a decent custom for around £350

pm me and ill send you some large pot £12 plus post

have you sorted them hubs out ?

take the bulb out and point a hairdryer in the hole with medium heat then get some silica gel bags and put them in the lights behind the lenses no more problem

hydrogen conversions are where its at

i would change the coil pack before the leads and plugs esp with the wet weather we have had the coil pack isnt sealed too well

depends how worn they are you may get an advise or a fail

this happened to me 2 weeks ago, pulled me gave him my ins cert with mods on it only all were not on the cert, everything is declared though. decent copper knew what he was looking for but they are clamping down on it. this coppers reason was an influx of modded cars being un road worthy due to...

for a cheap option go for AMD sempron, asrock motherboard and 1 gig of ddr2 memory you could get that lot for £120ish or go for a nice new base unit http://www.microdirect.co.uk/systems.aspx the genie system is very good for the money

you would struggle to get such a spec and a 3 year warranty plus the software included for a better price i'd buy it

the pannel is samsung too

dremmels cannot be beaten the cheaper ones dont have as much torque. ive had mine for 5 years now never failed me

ive sent loads of stuff to the continent always gets there if you send it registered. you will get a good price if selling them in france etc. you could sell the bulbs starters and balasts in a package but i doubt you would get a good price

sell them on ebay open it up to french and german customer etc you will get much more they are worthless here even at £100

Downstream 1,434.7 Kbps ( = 1.4 Mbps ) Upstream 1,628.9 Kbps ( = 1.6 Mbps )

pin 1 on the ECU . if you take the metal cover off the connector is numbered

its dead easy take inlet plenium part off 10 at the front and female torx on the top. it happned to mine many moons ago the plastic plenium was cracked due to 75shot of nos

Another cup bites the dust the cup interior is the el chepo of el chepos plus you prob have air bags in your seats the cup doesnt

what car is it, ensure the connector for the ecu is connected properly, check the wiring to the temp sensor , the accual sensors are pretty rugged its the wiring that can become snaged or frayed

have they told you why you need new injectors? most of the time they can be ultrasonicly cleaned for a fraction of the new cost

good info that cheers