Iv recently had my valver lowered at the front -35mm and the rear lowered so that the lip of the arch is level with the top of the phase II standard 15" rim. I want to fit a 16" rim but will i need to have the arches rolled????? I thought that the wheel diameter of the standard valver wheel 185/55/15 is the same diameter as 195/45/16 all I have to get is the correct offset. I want 16" so that the alloy disappears slightly at the rear. Would the width of 195 cause the wheel to rub on the back as my valver has been lowered so much??
Any feedback would be greatly appreciated.
Cheers
