A dumb question about lights

[williams dp]

Can anyone tell me how to get at the bulbs in the rear light clusters of a Williams 2? Im sure this is a really dumb question and it will be bloody obvious when explained but i cant figure the fcuking things out!

[Edited by williams dp on 17 August 2004 at 6:47pm]

 

[derv]

theres like a black plastic nut on the inside of the boot, un fasten that, till it comes off, then just wiggle the light cluster till it comes out! simple!

 

[Chris1.4RT]

Try a hammer from the outside.

 

[SAM113L]

Open the boot, look in the corners where the lights are and youll see a black star shaped nut unscrew this (one per side as this holds the light to the car!) Move the light cluster forward.

If you are working on the RH lamp there will be a wiring loom attached, unclip this and the light is free from the car. If it is the LH lamp then there is two wiring looms attached. One is the same as the RH side one so unclip that, the other should be a small black plug - unclip this. This is fed into the light from the underneath through a rubber seal - this just pulls out with the black plug!

With both lights free, the bulb holder is released by pressing the two clips either side on the bulb holder!

 

[Chris1.4RT]

Still think a hammers quicker.

 

[SAM113L]

LOL ^^