Ariel Blank

[KitsonRis]

Removed the ariel and it's left two small hols (4mm and a 10mm). Currently it is gaffa tapped up, but I am getting the roof wrapped as water marks have burnt into the lacquer and its cheaper than getting it painted, it's a track car so would rather spend the money on performance upgrades.

So what have people done to fill the holes....cheap and simple. I cannot weld, and I don't really want to put filler and that in unless I have too. Was thinking just some small blind grommets. Just wanted to know what else has been done.

 

[GrahamS]

I've used a plastic square bung from ebay, cost me about a quid. Yet to put silicon around it but it does the job. Think they're the things you see in the end of office furniture, just silicon it in.

 

[KitsonRis]

Didn't think about sealing them after with silicone, that isn't a bad shout!
What I'll probably do it get some grommets and then give them to whoever wraps the roof to put in aafter so it's a neat finish. I would wrap it myself by after the botched sun strip I am not doing a roof!!

 

[eon172]

I initially used one of the inner wing (plastics) circular fixings and siliconed it on, it's a large diameter so covers well. I only had a large single hole to cover. Then touched it up for a rough paint match. I've since fiberglassed and filled as I'm about to wrap the roof myself.

Sent from my SM-G930F using Tapatalk