Banded steelies will they fit?

[Dgrehan]

Looking to get banded steeliness on my mk 2 clio but have no idea if they will fit! The specs are 4 x 100 with a 65.1 centre bore which I know could be too big! And are 9.5 j on the front and 10 j on the back. Will they fit properly?
thanks

 

[JAMason]

I might be wrong here but i cant see them being a direct fit. They are HUGE...10J and 9.5J would never go on with out serious arch pulling and some spacing being done to clear the inner arch. Whats the ET like on them?

 

[Dgrehan]

I might be wrong here but i cant see them being a direct fit. They are HUGE...10J and 9.5J would never go on with out serious arch pulling and some spacing being done to clear the inner arch. Whats the ET like on them?

Doesn't say in the advert but I emailed them to see if they could make some specifically for the clio! I have wheels on not that done exactly for and I'm trying to get rid of that problem but in a stylish way! Thanks though

 

[Loz H]

an extra 3" wide? jeeeesus!.

Depending on the offset, you may not need spacers. But your probably going to need to crack the roller out for the arches :rasp:

 

[DanEdser]

10" would be ridiculously huge on a Clio! 10" is pretty big even on a Skyline!

Plus RWD stagger fitment on a FWD car? Each to their own...

If you get them... Good luck getting them to fit!

 

[105e]

Wont be doing the unsprung weight any favours.

 

[Wazzy]

I've just googled to check and all I see is Corsa B's, so I closed the page.

 

[Dgrehan]

yeah definitely wont be going with these they ae too big!! thanks for the reply guys!

 

[hilldawg172]

10j is completely pointless on a clio! Its not a 800bhp supra.

 

[JackD]

1.2 clios are notoriously difficult to put their power down though

 

[Kneesparks]

Way too big. I run 9.5j on my skyline with 265 tyres they would never fit a clio without a big arch extension.