Bigfoot said:9psi is there normal setup conversion, running about 200bhp they say, if you had all the works you should be looking at running a lot more psi than that. the full works basically their spec engine you can run in excess of 20psi. their basic conversion including fitting is jusy over 5k i think, a 2nd hand one worth even less than that, parts along only cost around 4k for the conversion. wiring loom over 100 quid. small over parts not even going to be over 1k. Think there was one of their converted cars going on ebay for 3.5k which weren't too bad. Think that clio on the site for sale is a joke though, who would buy a clio for 15k when its only running just over 200bhp.
ben_p said:id sell the mrk1 for 1-3k add my 12.5k = 15.5k and buy a real car
! CLIO TURBO ! said:NOT TO FORGET ITS GOING TO BE A COVER CAR FOR REVS!
! CLIO TURBO ! said:NOT TO FORGET ITS GOING TO BE A COVER CAR FOR REVS!
stan* said:i'd rather have 5k in my pocket.
ps it would paste your rsralph wiggum said:OOH f**k a duck must be good![]()
Bigfoot said:Why would you sell that clio when its the best modded one out there. wouldn't it be cheaper to just sell yours with your engine in there and just transfer what parts you want over to the new one? It has the low comp conversion then, which sounds about right for that sort of power. Im just after now a clutch, as the valeo one i have wont be too good for the power im going to run, Also after a clio 172 gearbox, main reason why i joined this forum. and need to get hold of a screen, so i can view loads of readings which my ECU is going to give as an output, cant wait to see that all up and workingalso found out that the ECU im having has two setups, so can run petrol saving setup at like 5psi, and also have another one which is like 18psi or whatever i decide to go for. This car is costing me a fortune lol, and i wont be selling it whatever the circumstances are.
Sami said:247bhp is nothing to be laughing about! least it isn't a body kit with a 1.2 in![]()
Might be a daft question but does the 172 gearbox you have come from a phase 1 / CUp as you'll need one unless your speedo input comes from something else as the Mk1's use the gearbox sensor to detect speed the 172 excluding the phase 1 some early phae 2 (very few) and Cups didn't have gearbox sensors as they use the ABS system.Bigfoot said:Its is BBPT R-Tuner Prgrammable ECU version 2. Setting it up on the road first of all but will more than likely get it rolling roaded sometime to see what sort of power its running at. Got myself the 172 gearbox on the way now, so just need to sort out a couple of more things.
ralph wiggum said:OOH f**k a duck must be good![]()