Clunkity clunk

[Tin.tin]

Hi all

Car has been faultless for a while so decided to break it in pursuit of a little squeak 😂

When turning the ignition off, the shake from engine shutting down made something squeak. It was coming from exhaust/dogbone area.

After spraying a bit of silicone grease on the mount, it stopped squeaking.

That plus vibration under tension from clutch I decided it was time to change mount. Already had a QH mount so I fitted that.

Was fine initially but over 3/4 days car has developed a clunk/knock in 1st & 2nd at low speeds when coming off the accelerator.

Progressively getting louder tonight compared to this morning.

Sounds like it’s coming from driver’s side. To make things more exciting , now when I shut the engine down, the shake makes a racket from dogbone area.

 

[Márquez6]

Maybe it’s a worn dogbone mount or a lower gearbox mount (under the battery) or both.

 

[Tin.tin]

Maybe it’s a worn dogbone mount or a lower gearbox mount (under the battery) or both.

thanks for replying mate will go under battery tomorrow suspect this has never been replaced from factory also

 

[Tin.tin]

Managed to get a video. Not normal this is it?

 

[R3k1355]

I'd do both mounts while you're at it, neither are very difficult to replace. That one there and the gearbox side mount.

 

[Márquez6]

i don’t think that’s normal,not sure the one under the battery actually does much.when I replaced my top engine mount I bought of a powerflex upper right mount insert(yellow),not sure it does anything.I replaced all the engine mounts and the dog bone all in one go.

 

[Márquez6]

.

 

[Tin.tin]

I'd do both mounts while you're at it, neither are very difficult to replace. That one there and the gearbox side mount.

Cheers ordering both now, hopefully have enough time to frolic in the sunshine afterwards!

 

[Tin.tin]

i don’t think that’s normal,not sure the one under the battery actually does much.when I replaced my top engine mount I bought of a powerflex upper right mount insert(yellow),not sure it does anything.I replaced all the engine mounts and the dog bone all in one go.

Makes sense doing them all at the same tbh I should have done what you did. Which brand dogbone did you fit? struggling to find one suitable for 182. My old one wasn't too bad anyhow think I will put that back in for now.

 

[Mr Trailer Man]

Makes sense doing them all at the same tbh I should have done what you did. Which brand dogbone did you fit? struggling to find one suitable for 182. My old one wasn't to bad anyhow I think I will put that back in for now.

Factory mount with purple powerflex bushes is what you want.

 

[Tin.tin]

Factory mount with purple powerflex bushes is what you want.

Cheers. someone on Facebook sick of theirs hopefully can relieve them of it.

 

[Márquez6]

Makes sense doing them all at the same tbh I should have done what you did. Which brand dogbone did you fit? struggling to find one suitable for 182. My old one wasn't too bad anyhow think I will put that back in for now.

I bought the purple powerflex one,there was a bit of vibration but it settled down,then I bought a bespoke one from a guy off here that gave more give that the solid powerflex one.