Laguna hubs on the Clio Williams

[ClioMaxi]

How did you get the mk1 rear stub axles out? Does it go back through away from where the wheel would be?

The mk1 stub axle seems to be part of the rear beam?

yes they push out inwards.. i needed a 20 tonne press and 2 people to steady it

 

[Brigsy]

Ive seen a few people cut the stub axle flush with the beam instead of removing fully, might be an option if no access to a press.

 

[GasManLS7]

Probably end up doing that to be fair

 

[GasManLS7]

these were the spacers and caliper holders. i looked up and i used laguna 4 stud rear hubs and espace discs then a mix of csliper parts..View attachment 1759321View attachment 1759322

What size stub axle spacers did you use? I think ideally I need 40mm:

Just wondering if that's taking the piss with the bolts a bit?

 

[ClioMaxi]

i cant remembwr exactly but about 35mm i think.. and used 10.9 bolts m8 if i remember so thw original beam holes were opened out as i think they wer m6 orginally

 

[GasManLS7]

these were the spacers and caliper holders. i looked up and i used laguna 4 stud rear hubs and espace discs then a mix of csliper parts..View attachment 1759321View attachment 1759322

Hi mate, do you still have the file for the spacer? Looking at getting one made so I can have it in one piece rather than this:

 

[ClioMaxi]

i might have it somewhere but im out of the county at the moment. id have to try an check over christmas when im back