List your modifications

[Mwindow]

Janspeed exhaust w/ unsilenced mid-section
Yozzasport de-cat
GDI Inlets
Hillpower Elbow
Pipercross cone filter
Ferredo D2500 pads
Yokohama Paradas
Sony 9800BT headunit

How much of a difference hav those mods made to the car?

 

[kully]

would make the car more responsive , better feel on the road and about 10/15bhp quicker

 

[Lagerlout]

GDI/Piper cat back exhaust
Janspeed silenced decat
Uprated Fuel Pressure regulator
ITG Maxogen
Hillpower Ported Inlet Manifold
Clio Cup Turinis
EBC Greenstuff pads front
Tarox rears
GroupN ECU (being replaced by RS Tuning remap)
Hillpower strut top covers
Alpine speakers. Which are fucked.
Silverfusion lamps

ummm that's about it....... Suspension next I reckon.

 

[Markpw]

AWT inlets and higher lift Cat cams
Samco induction elbow
ITG panel with 75mm CAF from OE box down to where acoustic valve was
Ktec Stealth 2
PMurray remap
Brembo cross drilled front discs with standard rear, greenstuff pads all round
Moquip braided hoses
H&R coilovers
Gumball 3000 sticker !!! (defo worth another 2 bhp)

 

[Markyx2cuk]

bare in mind i hav only had the cup 5 months so mods are to a minimum!! but so far...

ITG Panel Filter
Ktec/Janspeed Recessed Exhaust System
Janspeed De Cat
Brembo HC Discs
Pagid Blue Pads
Braided Hoses
5:1 Dot Fluid
Polished Header Tank
16" Turini's ( due to be painted White next week )
Eagle F1's all round
H&R's ( due to b fitted this weekend )

i am also ordering some more goodies for the car within the next week or two...

Cobra Seats ( undecided but prob Misano's )
Roll Cage ( also undecided as to what one )

 

[ayk2008]

- Zimmerman drilled disks (front)
- EBC Greenstuff pads (all round)
- Goodridge braided brake lines (all round)

Suspension:
- Bilstein B14 PSS kit
- Powerflex susp. bushes
- KTR solid susp. top mounts (come, but to be installed)

Engine:
- Magnecore 8.5 leads
- Powerflex dogbone engine mount
- Samco silicone hoses (come, but to be installed)
- ITG panel air filter (to be replaced with some induction kit soon)

Exhaust:
- Supersprint catback with 2-tailpipes

Interior:
- Sparco Rev seats (rear seat is removed)
- Sabelt 4-point belts
- Momo Montecarlo 320 mm weel
- Momo foot pedals, gear knob, handbrake, alu mats
- LEDs

Wheels &Tyres
- 16" 7J forged
- 205/45 Michelin PE2
- Richbrook flushift valve set

Exterior
- 4" Racesport aerial
- LED stop&tail, turn, rear, number plate etc lights

P.S. I am from Russia, not all what I want is available here

 

[LegoHead]

Clifford concept 650
Intellistart bypass module
Glass break sensor
Headlight timer
Window closure
RAC trackstar

BBPT 182 blue flame exhaust system
Grp. N ECU reflash
MB engineering short throw shifter
Green Cotton induction kit
Goodridge braided brake line
Bailey Alloy header tank
Silicon water hoses
Magnecor HT leads
Polished engine parts
Brake painting

Supaguard protection
Paint sealant
Carpetguard
Fabricguard
Vinyly guard

front discs brembo max grooved discs
front pads ferodo ds2500
2 x Michelin PE2s
2 x Dunlop sport 3000
Powertec Manual boost controller
Garrett T28 hybrid turbo with oil and water cooling - Low boost set at 10psi
Charge cooler, header tank and pump.
Grp N ecu with 7800 rpm rev limiter
Uprated Paddle Clutch
Wossner Forged Pistons
Sat Nav dashtop with tv
JVC mp3 headunit
JBL component speakers
Bluetooth handsfree kit
Prosport stepper boost gauge
Prosport Oil pressure gauge
Prosport oil temperature gauge
Battery relocation to boot with fibreglass box.

JBL sub and amp in boot.

Mine has now changed a little bit.

 

[kevinhall]

ITG maxogen
Orbisoud (loud) exhaust

Pagid blues
Brembo max discs
Braided lines (all round)
5:1 dot fluid

Interior stripped
Cobra Evolution buckets
Sparco 3 point snap in harnesses
Caged half roll cage
Sparco 300mm wheel

To come:
AST coilovers and solid top mounts
Buddy club P1s and R888s or similar
Remap

 

[paul]

1/ctr aerial
2/renault rubber mats with ff 182 rear mat
3/painted 182 wheels (inside) to match outside
4/painted 182 back box
5/painted engine cover inferno c/w sticker
6/painted interior trims inferno c/w sticker
7/painted calipers black and inner hubs etc
8/painted rear axle
9/ff door sill trims
10/cobra daytona seats (home made pretentioner covers in same fabric)
11/evo sticker
12/silver bulbs all round
13/alu tax disk cover

and 99% of the time kept toped up with spr and egp! :approve:

 

[iain187]

Janspeed Sport cat
Milltek cat back

new pirelli tyres on order (will be here next monday!)

plans:

upgrade the brake system
get the inlets done
maybe an induction kit
then a remap

and a track day

 

[mx1_champ]

exterior
-172bumpers
-172 wings
-172 skirts
-172 spoiler
-respray blue (forgotten the name )
-tinted windows
-2.0 16v badges
-kosei sniper 17'' alloys

interior
- 172 half leathers
-alcantara door cards
-momo steering wheel + 172 sterring wheel
-LM audio dvd head unit
-boost gauge+ pod
-fusion components + tweeters
-2 10'' kicker competition subs
-fusion 1000w amp
-pheonix gold amp
-pioneer 6x9
-rear strut brace

suspension + brakes
-172 suspension lowered 40mm
-172 brakes
-172 wishbones, shafts hubs.

engine
-derv doctor remap
-derv doctor dump valve
-fmic ( needs fitting)
-induction kit +cold air feed
-2.5'' outwardly rolled exhaust
-dci 80 turbo